6-4 Installation and Service Guide N5250-90001
Performance Tests and Checks
System Check
PNA Series Microwave Network Analyzer System
N5250A
S
ystem Check
1. Connect a 1.0 mm sho
rt to Port 1 and Port 2. An adapter may be used on Port 2.
2. Restart the PNA application and perform a factory preset by pressing the PRESET key.
3. On the PNA menu bar, select: System > Service > Utilities > Receiver Display.
4. Set the IF bandwidth to 1 kHz.
The traces on the display should be similar to the example traces shown in Figure 6-1. If there
are power holes o
r other unexpected characteristics, examine the system for loose or damaged
cables, dirty or damaged connectors, proper connector torque, etc.
Figure
6-1
Typical Receiver Display
When you have a display that represents the current system performance, capture the display in
a file and save the file in the directory D:\sysver results (create this directory if it does not
already exist). To capture the display in a file, select: File > Print. An example of a recommended
file name is “opcheck_Sep_15_2016.png”.
To Next Page
Loading...
Need help?
General
