112 Chapter 6
Troubleshooting
Software
Software
Removing the Software
If it is necessary to remove the N8241A software, go to:
Start > Settings > Control Panel > Add/Remove Programs
1. Select Agilent N8241A AWG (Version), then select Remove.
2. You may need to restart the PC, but this will completely remove all of the files.
Moving the Software
If it becomes necessary to move the N8241A software, complete the instructions
documented in
Removing the Software. Then, using the N8241A CD, reinstall the
software where it is needed.
Updating the Software
To resolve an error message you get while attempting to upgrade the N8241A
software, take the following steps in the listed order:
1. Go to: Start > Settings > Control Panel > Add/Remove Programs
2. Select Agilent N8241A AWG (Version), then select Remove.
3. You may need to restart the PC, but this will completely remove all of the files.
4. Reinstall the N8241A software.
To Next Page
Loading...
Need help?
General
