7Formats and Data Flow
208 Keysight 53210A User’s Guide
<file> is created during execution of the STORe command. The parameter format
is “[
drive:path]<file_name>”. drive is either INT (internal flash memory) or USB
(external memory device).
path is an absolute path and folder name. If a folder is
specified, it must have been previously created (see
MMEMory:MDIRectory).
The combination of folder and file name cannot exceed 240 characters, and
cannot contain the characters \ / : * ? “ < > |. State files have a .sta extension.
State File Example
The following example shows the interaction between folders created from the
front panel and state files created/stored programmatically. For this sequence,
folder
SETUP_1 was created on the internal flash drive from the front panel. It is
then specified (programmatically) as the current folder and a state file is stored
and recalled from that folder.
MMEM:CDIR “INT:\SETUP_1” // specify as current folder
configure instrument programmatically or from front panel
MMEM:STOR:STAT “test1.sta” // store the configuration
recall the configuration (state) at later date (even if power is
cycled)...
MMEM:LOAD:STAT “INT:\SETUP_1\test1.sta” // load state
Saving States from the Front Panel
With the instrument configured as required, the state is stored from the front
panel as follows:
1 Use the Utility key and soft keys indicated on the previous page to set file
action ‘Store’.
2 Press the ‘Browse’ soft key to display the ‘File System’ window. Use the front
panel knob to highlight the root directory or a folder in the counter’s internal
flash memory (Internal) or on the USB drive (External). If folders are not visible,
press ‘Browse’ again to view the directory structure.
To Next Page
Loading...
