Keysight 53210A - Figure 2-5 Adding a Sockets Connection

2 53210A Software Installation and Interface Configuration
62 Keysight 53210A User’s Guide
Figure 2-5 Adding a Sockets Connection.
About IP Addresses and Host Names
Dynamic Host Configuration Protocol (DHCP) and Automatic IP are enabled on
the 53210A when shipped from Keysight. This allows the instrument to
automatically obtain an address on the network. If there is a DHCP server on the
network, the server will assign the address to the instrument.
If there is not a DHCP server on the network, the 53210A will automatically
determine the address to use. The address will be in the range 169.254.1.1 to
169.254.255.255.