Keysight E3634A User Manual

Remote Interface Reference 4
Keysight E3633A and E3634A User’s Guide 111
Using the APPLy Command
The APPLy command provides the most straightforward method to program the
power supply over the remote interface. You can select the output voltage and
current in one command.
APPLy {<voltage>| DEF|MIN|MAX}[,{<current>| DEF|MIN|MAX}]
This command is combination of VOLTage and CURRent commands. As long as
the newly programmed values are within the presently selected range, the
output voltage and current are changed as soon as the command is executed.
The
APPLy command changes the power supply’s output to the newly
programmed values only if the programmed values are valid within the
presently selected range. An execution error will occur if the programmed
values are not valid within the selected range.
You can substitute “
MINimum ”, “ MAXimum ”, or “ DEFault ’’ in place of a specific
value for the voltage and current parameters.
MIN selects the lowest values of
“0” volts and “0” amps.
MAX selects the highest values allowed for the selected
range.
The default values of voltage and current are “0” volts and “20”
[1]
or “7”
[2]
amps
regardless of the presently selected range. For more details of parameters, see
Table 4-1 for the Keysight E3633A model and Table 4-2 for the Keysight
E3634A model.
If you specify only one parameter of the
APPLy command, the power supply
regards it as voltage setting value.
[1] For Keysight E3633A Model
[2] For Keysight E3634A Model

Keysight E3634A Specifications

General

Brand	Keysight
Model	E3634A
Category	Power Supply
Language	English