Keysight E3634A User Manual

Front-Panel Operation 3
Keysight E3633A and E3634A User’s Guide 57
4 Save the operating state.
The operating state is now stored. To recall the stored state, go to the
following steps.
5Turn on the recall mode.
Memory location “1” will be displayed in the recall mode.
This message appears on the display for approximately 3 seconds.
6 Recall the stored operating state.
Turn the knob to the right to change the displayed storage location to 3.
If this setting is not followed within 3 seconds with key stroke, the
power supply returns to normal operating mode and will not recall the
instrument state 3 from memory.
7 Restore the operating state.
The power supply should now be configured in the same state as when you
stored the state on the previous steps.
This message appears on the display for approximately 1 second.
– Remote interface operation:
DONE
RECALL 1
RECALL 3
DONE
*SAL {1|2|3} Store an operating state to a specified location
*RCL {1|2|3} Recall a previously stored state from a specified location

Keysight E3634A Specifications

General

Brand	Keysight
Model	E3634A
Category	Power Supply
Language	English