Keysight E5071C ENA Series User Manual

18 Keysight E5071C ENA Series RF Network Analyzers
Installation
Installing Front Handles/Rack Mounting Flanges
2-
How to Install the Rack-mount Kit (Option 1CM)
The rack-mount kit includes two flanges (locking side plates) for mounting the
E5071C on a rack (482.6 mm/19 inches) conforming to the EIA Standard.
While referring to Figure 2-3, install the rack-mount kit by following these
steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame
of the E5071C front panel.
Step 2. Use the provided screws to mount a rack-mounting flange (4) on each side of
the E5071C front panel frame.
Step 3. Remove the four bottom feet of the E5071C (lift the bar marked TAB on the
inner side of the foot and slide the foot toward the bar).
Step 4. Mount the E5071C on the rack.
How to Install the Rack-mount and Handle Kit (Option 1CP)
The rack-mount and handle kit includes both the rack-mounting flanges
(locking side plates) and front handles. While referring to Figure 2-3, install the
rack-mount kit by following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame
of the E5071C front panel.
Step 2. Use the provided screws to mount a front handle (2) and rack-mounting
flange (4) on each side of the E5071C front panel frame.
Step 3. Remove the four bottom feet of the E5071C (lift the bar marked TAB on the
inner side of the foot and slide the foot toward the bar).
Step 4. Mount the E5071C on the rack.
Use both a front handle and a rack-mounting flange in the same time
certainly. Do not attempt to install flanges or handles separately with
hardware provided. Serious electrical damage will occur to the instrument.

Keysight E5071C ENA Series Specifications

General

Number of Ports	2 or 4
Dynamic Range	>123 dB (typical)
Connectivity	LAN, USB, GPIB
Display	10.4-inch LCD
Trace Noise	0.004 dB rms
Impedance	50 Ohm
Weight	20 kg
Dimensions	426 mm × 177 mm × 407 mm