Keysight E5071C ENA Series User Manual

Keysight E5071C ENA Series RF Network Analyzers 41
Troubleshooting
System Recovery
Types of system recoveries
The following 2 types of system recoveries are available.
o Factory recovery
Returns the contents of the C drive to the factory state.
Available for all Windows OS licenses.
o User recovery (available only for Windows Vista Business with HDD revision
CN924 or below)
Returns the contents of the C and D drives to a user-specified state.
To use this function, you must prepare for recovery in advance.
For information on the preparation, see “Procedure to create the user
backup image (only available when HDD Revision is CN924 or below)” on
page 53 for information on the execution, see “Procedure to execute the
user recovery function (only available when HDD Revision is CN924 or
below)” on page 60.
Factory Recovery
Notes on executing factory recovery function
Executing the factory recovery function causes the following conditions:
o In addition to the Windows operating system, the following settings of the
E5071C are returned to the factory state.
•Network setting
• GPIB setting
•Printer setting
o The driver for the supported printer installed after purchase is deleted.
o You need to execute initial registration again.
o The firmware revision you installed remains even if you perform factory
recovery.
Files you created using the save function (files in the D drive) are not affected,
but we recommend backing them up before executing system recovery for
precautionary purposes. For more information on backup, refer to “Backing Up
the Data” as described in E5071C Online Help.

Keysight E5071C ENA Series Specifications

General

Number of Ports	2 or 4
Dynamic Range	>123 dB (typical)
Connectivity	LAN, USB, GPIB
Display	10.4-inch LCD
Trace Noise	0.004 dB rms
Impedance	50 Ohm
Weight	20 kg
Dimensions	426 mm × 177 mm × 407 mm