Keysight E5071C ENA Series User Manual

11
Keysight E5071C ENA Series RF Network Analyzers
Installation Guide
2 Installation
This chapter provides information about how to set up the Keysight E5071C.
Contents of this
Chapter
o “Checking the Shipment” on page 12
After you receive the analyzer, check all the items in the packing container.
o “Environmental Requirements” on page 13
Describes the system requirements needed to install the E5071C and how to
secure space for heat radiation.
o “Installing Front Handles/Rack Mounting Flanges” on page 16
Shows how to mount the front handles used to transport the E5071C and how
to install the flanges needed to install it in a rack.
o “Connecting the Accessories” on page 19
Provides information for connecting the mouse, keyboard, BNC adaptor to the
E5071C.
o “Power Supply” on page 20
Shows how to check the power supply as well as check and connect the power
cable.
o “Starting the E5071C” on page 22
Describes turning on/off of the Power switch and cutting off the power supply.
o “Initial Registration of E5071C” on page 26
Provides the procedure of initial registration for the Windows XP operating
system of the E5071C.

Keysight E5071C ENA Series Specifications

General

Number of Ports	2 or 4
Dynamic Range	>123 dB (typical)
Connectivity	LAN, USB, GPIB
Display	10.4-inch LCD
Trace Noise	0.004 dB rms
Impedance	50 Ohm
Weight	20 kg
Dimensions	426 mm × 177 mm × 407 mm