Keysight E5071C ENA Series RF Network Analyzers 23
Installation
Starting the E5071C
Step 3. Press the standby switch to put it in the depressed position ( ).
This operation turns ON the power, and the E5071C starts the self-test.
Step 4. Confirm that the self-test indicates normal operation.
Normal operation is confirmed by the self-test if no error message appears.
Turning the Power OFF
Step 1. Use either of the following methods to turn the power OFF.
• Press the standby switch ( ) in the lower-left part of the front panel (now
in the pressed down ( ) position) to put it in the popped up ( )
position.
• Click Turn off Computer from Windows Start menu
These operations will start the E5071C shutdown process (required software
and hardware processes for turning the power off), and the power will turn
OFF after a few seconds.
Under normal circumstances, always press the standby switch ( ), or
click Turn off Computer from Windows Start menu, to execute the E5071C
shutdown process. Never cut off the power supply directly by
disconnecting the power cable plug from the rear panel of the unit.
If the power supply is cut off directly by disconnecting the power cable
plug from the instrument or the AC outlet, the shutdown process is not
carried out and there is a risk of damage to the E5071C’s software or
hardware.