B Configure External Instruments
58 Keysight E6961A User Guide and Method of Implementation
Introduction
For each test, the DSOS254A Infiniium Oscilloscope automatically configures any
external instruments (AWG, E5071C ENA, and E9010B EXA Signal Analyzer) as
required for the test. In order to do this, however, the oscilloscope must know the
SICL address of each instrument. The External Instruments Status indicator is red
if the instruments are not properly configured.
1 From the BroadR-Reach Compliance Test Application Set Up tab, click the
Configure button.
Figure B-1 BroadR-Reach Compliance Test Application Main Menu
The instruments must be connected to the oscilloscope prior to configuring
them. This is generally through a USB connection.
Note that the 33250A AWGs require an 82357B USB/GPIB interface. You must
configure the Master and Slave 33250A AWGs separately.
To Next Page
Loading...
