Using the E6960-66600 Frequency Divider Board D
Keysight E6961A User Guide and Method of Implementation 69
Static-safe Handling Procedures
Electrostatic discharge (ESD) can
damage or destroy electronic
components. Use a static-safe work
station to perform at work on
electronic assemblies. This figure
shows a static-safe work station using
two types of ESD protection:
– Conductive table-mat and
wrist-strap combination
– Conductive floor-mat and
heel-strap combination
Both types, when used together,
provide a significant level of ESD
protection. Of the two, only the table-mat and wrist-strap combination provides
adequate ESD protection when used alone. To ensure user safety, the static-safe
accessories must provide at least 1 MΩ of isolation from ground.
Observe appropriate ESD precautions before connecting and disconnecting
cables and changing the positions of jumpers ans switches.
To use the divider board, check the Use 10MHz Ref Clock on the BroadR-Reach
Compliance Test Application Main Window.
To Next Page
Loading...
