538 Keysight N9927-90001 User’s Guide
System Settings
System Configuration
— When the installation is completed, the FieldFox reboots.
How to backup files
This procedure backs up your user data to a USB or SD card. See also “How to
restore files” on page 538.
From the initial Installer menu:
—Press Utility
—Then Backup Data
— A message is displayed: “Choose backup file location.”
— Then choose either SD Card
or USB
— A progress bar and a message is displayed: “Saving user data…”
—Press Cancel
to exit without backing up your files and returning to the initial
Installer menu.
How to restore files
This procedure restores user files from a USB or SD card. See also “How to backup
files” on page 538
.
If your stored any user files to a USB or SD card, this procedure restores those
files.
From the initial Installer menu:
—Press Utility
—Then Cancel to exit without restoring your files and returning to the initial
Installer menu.
Or
Press Restore Data
If you backup multiple versions of the user files, the FieldFox appends a
“_#” to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox.
Restoring files overwrites the existing user data on the FieldFox.
If you backup multiple versions of the user files, the FieldFox appends a
“_#” to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox
To Next Page
Loading...
Need help?
General
