Keysight InfiniiVision DSOX1204A User Manual

Getting Started 1
Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide 15
Input a Waveform
The Probe Comp signal is used for compensating probes.
1 Connect an oscilloscope probe from channel 1 to the Demo, Probe Comp terminal
on the front panel.
2 Connect the probe's ground lead to the ground terminal (next to the Demo
terminal).
WARNING
A voltage source should never be connected to the ground terminal of this instrument.
If, for any reason, the Protective Conductor Terminal is disconnected or not functioning
properly and a voltage source is connected to the equipment's ground terminals, the
entire chassis will be at the voltage potential of the voltage source, and the operator or
bystanders could receive an electric shock.

Keysight InfiniiVision DSOX1204A Specifications

General

Brand	Keysight
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English