Quick Reference 2
Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide 91
Stand-alone (Point-to-Point) Connection to a PC
The following procedure describes how to establish a point-to-point (stand alone)
connection to the oscilloscope. This is useful if you want to control the
oscilloscope using a laptop computer or a stand-alone computer.
1 Press [Utility] > I/O.
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic, and press
the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
4 Connect your PC to the oscilloscope using a cross-over LAN cable such as
Keysight part number 5061-0701, available on the web at
www.keysight.com/find/parts.
5 Cycle power on the oscilloscope. Wait until the LAN connection is configured:
• Press [Utility] > I/O and wait until the LAN status shows "configured".
This may take a few minutes.
Now, the instrument is connected, and the instrument's web interface or remote
control via LAN may be used.
USB Storage Devices
Use your PC to create directories on a USB storage device.
Most USB mass storage devices are compatible with the oscilloscope. However,
certain devices may be incompatible, and may not be able to be read or written to.
USB storage devices must be formatted with the FAT/FAT16, FAT32, NTFS, EXT2,
EXT3, or EXT4 file system format. The exFAT format is not supported. Any given
storage device may not support all of these formats.
When the USB mass storage device is connected to the oscilloscope's USB host
port, a small four-color circle icon may be displayed briefly as the USB storage
device is read.
You must "eject" a USB mass storage device before unplugging it; otherwise, the
device will be marked as needing repair when connecting to a computer with the
Windows operating system (even though there are no harmful effects to the
device).
To Next Page
Loading...
Need help?
General
