Quick Reference 2
Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide 93
Web Interface
When Keysight InfiniiVision 1000 X-Series oscilloscopes are set up on the LAN,
you can access the oscilloscope's built-in web server using a Java-enabled web
browser. The oscilloscope's web interface lets you:
• View information about the oscilloscope like its model number, serial number,
host name, IP address, and VISA (address) connect string.
• Control the oscilloscope using the Remote Front Panel.
• Send SCPI (Standard Commands for Programmable Instrumentation) remote
programming commands via the SCPI Commands applet window.
• Save setups, screen images, waveform data, and mask files.
• Recall setup files, reference waveform data files, or mask files.
• Get screen images and save or print them from the browser.
• Activate the Identification function to identify a particular instrument by
causing a message to be displayed or a front panel light to blink.
• View installed options, view firmware versions and install firmware upgrade
files, and view calibration status (via the Instrument Utilities page).
• View and modify the oscilloscope's network configuration.
The web interface for InfiniiVision X-Series oscilloscopes also provides help for
each of its pages.
Microsoft Internet Explorer is the recommended Web browser for communication
and control of the oscilloscope. Other Web browsers may work but are not
guaranteed to work with the oscilloscope. The Web browser must be
Java-enabled.
Before you can use the web interface, you must place the oscilloscope on the
network and set up its LAN connection.
Accessing the Web Interface
To access the oscilloscope's web interface:
1 Connect the oscilloscope to your LAN (see "To establish a LAN connection" on
page 89) or establish a point-to-point connection (see "Stand-alone
(Point-to-Point) Connection to a PC" on page 91).
It is possible to use a point-to-point connection, but using a normal LAN
connection is the preferred method.
To Next Page
Loading...
