Quick Reference 2
Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide 89
Setting up the Oscilloscope's LAN Connection
You can place the oscilloscope on the network and set up its LAN connection.
Once that is done, you can use the oscilloscope's web interface or remotely
control the oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or manual
LAN configuration (see "To establish a LAN connection" on page 89). It is also
possible to set up a point-to-point LAN connection between a PC and the
oscilloscope (see "Stand-alone (Point-to-Point) Connection to a PC" on page 91).
Once the oscilloscope is set up on the network, you can use the oscilloscope's
web page to view or change its network configuration and access additional
settings (like the network password). See "Web Interface" on page 93.
To establish a LAN connection
Automatic
Configuration
1 Press [Utility] > I/O.
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic, and press
the softkey again to enable it.
Host ID export [Utility] > Service > Export Host ID >
The oscilloscope's Host ID is needed when redeeming licenses for oscilloscope upgrades or other
licensed features.
About oscilloscope [Help] > About Oscilloscope
Displays: model number, serial number, bandwidth, software version, and installed licenses
User interface
language
[Help] > Language
Table 32 Utility Features (continued)
Feature Front Panel Key/Softkey Location (see built-in help for more information)
Any time you modify the oscilloscope's hostname, it breaks the connection between the
oscilloscope and the LAN. You need to re-establish communication to the oscilloscope using
the new hostname.
To Next Page
Loading...
Need help?
General
