Keysight InfiniiVision DSOX1204A User Manual

Quick Reference 2
Keysight InfiniiVision DSOX1204A/G Oscilloscopes User's Guide 81
UART/RS232 bit order
[Analyze] > Bus Config > Bit Order, Entry knob (LSB, MSB)
UART/RS232 display
base
[Analyze] > Settings > Base, Entry knob (Hex, Binary, ASCII)
UART/RS232 framing
[Analyze] > Settings > Framing, Entry knob (Off, 8-bit hex value)
UART/RS232 counters [Analyze] > Settings > Reset UART Counters
Counters run even when the oscilloscope is stopped (not acquiring data).
When an overflow condition occurs, the counter displays OVERFLOW.
UART/RS232 trigger [Trigger] > Trigger Type, Serial 1 (UART/RS232)
[Trigger] > Trigger Setup > Trigger (Rx Start Bit, Rx Stop Bit, Rx Data, Rx 1:Data, Rx 0:Data, Rx
X:Data, Tx Start Bit, Tx Stop Bit, Tx Data, Tx 1:Data, Tx 0:Data, Tx X:Data, Rx or Tx Parity Error)
For triggers where you can specify data values, there are additional softkeys for specifying the data
comparison operator, the data value, the data value base (Hex or ASCII), and the Nth frame burst
count.
Table 29 UART/RS232 Decode/Trigger Features (continued)
Feature Front Panel Key/Softkey Location (see built-in help for more information)

Keysight InfiniiVision DSOX1204A Specifications

General

Brand	Keysight
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English