Keysight M8194A - Page 153

Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide 153
Remote Programming 4
• FILL: <segment_id> must exist. If pattern in file is larger than the
defined segment length, just ignore excessive samples. If pattern in
file is smaller than defined segment length, fill remaining samples
with <init_value>. <init_value> defaults to 0 if it is not
specified.
• <init_value> – optional initialization value. For non-I/Q format this
is a DAC value. For I/Q file format this is the I-part or Q-part of an I/Q
sample pair in binary format (int8). Defaults to 0 if not specified.
• <ignore_header_parameters> ON|OFF|1|0
This flag is used to specify if the header parameters need to be set. If
this flag is ‘ON’ header parameters will not be set. This flag is optional
and the default value is ‘OFF’ i.e. by default the header parameters are
set. This flag is applicable to formats (CSV and MAT89600) that contain
header parameters.
Parameter Suffix None
Description This command imports segment data from a file. It supports different file
formats. Using this command, you can fill an already existing segment, or
can create a new segment.
• <segment_id> must be 1
• <file_name> file name.
• <type> BIN. File format. (See File Type)
• <padding> ALENgth|FILL. (See Padding)
• <dac_value> a DAC value in binary format
Examples :TRAC1:IMP 1, "C:\Program Files (x86)\Keysight\M8194\
Examples\WaveformDataFiles\ Sin10MHzAt64GHz.bin",
BIN, IONLY, ON, ALEN
:TRACe[1|4]:MARKer[:STATe][?]
Command :TRACe[1|4]:MARKer[:STATe] OFF|ON|0|1
Query :TRACe[1|4]:MARKer[:STATe]?
Parameters OFF | ON | 0 | 1
Parameter Suffix None
Description Use this command to enable or disable markers for the selected segment.
The query form gets the current marker state.
Examples Command
:TRAC:MARK ON