Keysight M8194A - Page 152

152 Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide
4 Remote Programming
:TRACe[1|4]:IMPort[?]
Command :TRACe[1|4]:IMPort
<segment_id>,<file_name>,TXT|BIN|BIN8|IQBIN|BIN6030|B
IN5110|MAT89600|DSA90000|CSV,IONLy|QONLy,ON|OFF|1|0,[
,ALENgth|FILL][,<init_value>][,<ignore_header_paramet
ers>]
Query :TRACe[1|4]:IMPort?
Parameters <segment_id>,<file_name>,TXT|BIN|BIN8|IQBIN|BIN6030|B
IN5110|MAT89600|DSA90000|CSV,IONLy|QONLy,ON|OFF|1|0,[
,ALENgth|FILL][,<init_value>][,<ignore_header_paramet
ers>]
• File Format - Import segment data from a file. Different file formats are
supported. An already existing segment can be filled, or a new segment
can be created. This can be used to import real waveform data as well
as complex I/Q data.
• <segment_id> - the number of the segment, into which the data will
be written.
• <file_name> - the complete path of the file.
TXT|BIN|BIN8|IQBIN|BIN6030|BIN5110|MAT89600|DSA90000|CSV.
(See File Type) For details, see Supported File Types on page 94
• <data_type> - IONLy|QONLy. This parameter is only used, if the file
contains I/Q data.
• <marker_flag> - ON|OFF|1|0
This flag is used to specify if the marker data need to be downloaded or
not. If this flag is ‘OFF’ marker data will not be downloaded. Default
value is ‘ON’. This flag is applicable to BIN5110 format only. If BIN5110
format consists of full 16 bit DAC values (without markers) this flag
should be set to ‘OFF’ so that 2 LSB’s are ignored.
Since M8194A does not support markers this flag should be set to
‘OFF’.
• <padding> - ALENgth|FILL
• ALENgth: Automatic LENgth : <segment_id> may or may not
exist. After execution <segment_id> has exactly the length of the
pattern in file or a multiple of this length to fulfill granularity and
minimum segment length requirements. This behavior is default if
<padding> is omitted.