46 Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide
3 M8194A Soft Front Panel
• It is ‘RED’ if an over-voltage has been detected on that channel.
Potential overload conditions are e.g. an external short to GND
or 50 Ohm termination to a wrong externally applied
termination voltage VTerm. In case an overload condition is
detected, remove the overload condition of the test set-up and
re-enable the channel.
When the Stop button is pressed, the output voltage offset remains active
as long as the output port is enabled.
To Next Page
Loading...
