EasyManua.ls Logo

Keysight N9000B - Page 1484

Keysight N9000B
2650 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 VMA Mode
3.9 SEM Measurement
:SEM:OFFS:TYPE?
Notes OFFSet1 is for BTS, 2 for MS. Default is BTS
Note that Offset sub op code 2 is supported only in non-SA Modes. In SA Mode, Offset sub op code 1 is
used for both BTS and MS
Preset
CTOCenter
State Saved Saved in instrument state
Range Carrier Center to Meas BW Center | Carrier Center to Meas BW Edge | Carrier Edge to Meas BW Center |
Carrier Edge to Meas BW Edge
Mode: MSR, LTEAFDD, LTEATDD
Options:
CTOCenter
From the lowermost carrier center frequency (for lower offset), the uppermost
carrier center frequency (for upper offset) to the center of offset measuring
filter*
CTOEdge
From the lowermost carrier center frequency (for lower offset), the uppermost
carrier center frequency (for upper offset) to the nominal -3 dB point of the
offset measuring filter* closer to the carrier
ETOCenter
From the lowermost carrier center frequency - spacing of this carrier /2 (for
lower offset), the uppermost carrier center frequency + spacing of this carrier /2
(for upper offset) to the center frequency of offset measuring filter*
ETOEdge
From the lowermost carrier center frequency - spacing of this carrier /2 (for
lower offset), the uppermost carrier center frequency + spacing of this carrier /2
(for upper offset) to the nominal -3 dB point of the offset measuring filter* closer
to the carrier
RTOCenter
From either the lower or upper RF BW** edge frequency to the center frequency
of offset measuring filter*
RTOEdge
From either the lower or upper RF BW** edge frequency to the nominal -3 dB
point of the offset measuring filter* closer to the carrier
RCTOCenter
5G NR Mode only
From the center frequency of RF BW to the center frequency of offset measuring
filter*
*Measuring filter = Meas BW (N) x Res BW
** RF BW = BW
channel,CA
which is defined in each 3GPP standard, regardless of
“Measure Carrier” for the uppermost and the lowermost carriers being Enabled or
Disabled. When Number of Component Carriers = 1, RF BW = BW
channel
= 2 x
F
offset,RAT
Remote
Command
[:SENSe]:SEMask:OFFSet[1]|2[:OUTer]:TYPE CTOCenter | CTOEdge | ETOCenter |
ETOEdge | RTOCenter | RTOEdge
[:SENSe]:SEMask:OFFSet[1]|2[:OUTer]:TYPE?
Vector Modulation Analyzer Mode User's &Programmer's Reference 1484

Table of Contents

Other manuals for Keysight N9000B

Related product manuals