TOS93 Series User’s Manual 143
Protective Conductor Current Test
Finishing the Test and Viewing the Judgment
Stopping tests
If you want to stop a test or finish a test when the test time is off, press STOP.
Conditions that cause a test to end
Conditions that cause a test to end are as follows:
a.When a current greater than or equal to Upper limit or less than equal to Lower limit is measured
b.When the test time elapses if Test time is set to on
c. When you press STOP
In any of the cases above, the “TEST” indication on the display disappears when the test ends.
If the test finishes under condition a or b given above, the judgment result (p.144) will be shown on the dis-
play.
STOP
To Next Page
Loading...
