Kikusui TOS9300 - Page 9

TOS93 Series User’s Manual 9
Patient Leakage Current
Test
Setting Test Conditions ..................................145
Displaying the setup screen (Home menu) ........ 145
Description of test conditions.............................. 146
Network .............................................................. 146
Polarity of the power supply line......................... 147
Single fault mode (Condition) ............................. 148
Probe connection destination ............................. 149
Output from the 110% terminal (110% OUT) ..... 150
Upper limit .......................................................... 151
Lower limit .......................................................... 152
Judgment delay (Judge Delay) ........................... 153
Test time............................................................. 154
Measurement range ........................................... 155
Measurement mode (Measure Mode) ................ 156
Voltmeter band expansion (VoltMeter BandWidth) ..
157
Peak value display (Display Peakhold) .............. 158
Measurement check (Measure Check)............... 158
Offset .................................................................. 159
Voltage conversion (Conv Voltage) .................... 160
Checking the EUT operation (Line OUT)............ 160
Starting a Test ................................................161
Connecting the test leads to the EUT................. 161
Starting a test ..................................................... 163
Operation after a test starts ................................ 164
Finishing the Test and Viewing the Judgment166
Stopping tests..................................................... 166
Conditions that cause a test to end .................... 166
Judgment types and operation ........................... 167
Clearing the judgment result............................... 167
Meter Mode
Constructing the Measurement Circuit ...........169
Setting Measurement Conditions ...................170
Displaying the setup screen (Home menu) ........ 170
Overview of measurement conditions ................ 170
Network .............................................................. 171
Measuring across terminals A and B (A-B Terminal)
172
SELV setting....................................................... 173
Measurement range ........................................... 174
Measurement mode (Measure Mode) ................ 175
Measurement check (Measure Check)............... 175
Offset .................................................................. 176
Output from the 110% terminal (110% OUT) ..... 177
Polarity of the 110% output ................................ 178
Executing a Measurement..............................179
Connecting the test leads................................... 179
Taking measurements........................................ 179
Measurement operation ..................................... 180
Measurement example (judgment of the parts that
can be touched).................................................. 180
Auto Test
Auto Test Overview........................................182
Tests that auto test can run................................ 182
Programs and steps ........................................... 182
Main functions .................................................... 183
Program Configuration ...................................184
Displaying the program editing screen............... 184
Creating a program ............................................ 185
Changing a program name................................. 185
Deleting a program............................................. 186
Setting Steps..................................................187
Displaying the step editing screen...................... 187
Editing steps....................................................... 188
Program Operation Configuration ..................189
Fail judgment operation (FAIL Judgment) .......... 189
Step interval ....................................................... 190
Step start operation (Trigger Source)................. 191
EUT power supply (Line Break) ......................... 192
Running Auto Tests........................................193
Running an auto test .......................................... 193
Behavior during the test ..................................... 194
Finishing the Test and Viewing the Judgment195
Stopping tests..................................................... 195
Conditions that cause a test to end .................... 195
Judgment types and operation ........................... 196
Clearing the judgment result .............................. 196
Exporting and Importing Programs ................197
Exporting programs to a USB memory device ... 197
Importing programs from a USB memory device 198
External Control
SIGNAL I/O Connector...................................200
Pin arrangement................................................. 200
I/O signal circuit.................................................. 201
Input signal usage example................................ 202
Output signal usage example............................. 202
Connecting to the SIGNAL I/O connector .......... 203
Activating and Releasing Interlock .................204
Interlock activation conditions ............................ 204
Interlock release conditions................................ 204
Examples of how to use interlock....................... 205
Recalling from memory ..................................206