4. Regen.
The regen function is activated
when the joystick lever is pushed
one position further to the right
from the dump position. The regen
means “fast dumping”.
5. Down & roll back
The boom can be lowered and the
bucket can rolled back at same
time by operating the joystick lever
to the front left position (10 o’clock
position). However, the operation
time may not be shortened much
since the boom is lowered first
and then the bucket is rolled back
later due to unbalanced hydraulic
pressure in the hydraulic circuit.
6. Down & dump
The boom can be lowered and the
bucket can dump at same time by
operating the joystick lever to the
front right position (2 o’clock posi-
tion). However, these two opera-
tions may not be performed simulta-
neously due to unbalanced hydrau-
lic pressure in the hydraulic circuit.
7. Up & roll back
The boom can be lifted and the
bucket can scoop up at same time
by operating the joystick lever to
the rear left position (7 o’clock
position). However, these two
operations may not be performed
simultaneously due to unbalanced
hydraulic pressure in the hydraulic
circuit.
8. Up & dump
The boom can be lifted and the
bucket can dump at same time by
operating the joystick lever to the
rear right position (5 o’clock posi-
tion). However, the operation time
is may not shortened much since
the bucket dumps first and then
the boom is lifted later due to the
unbalanced hydraulic pressure in
the hydraulic circuit.
9. Locking/unlocking joystick
Pressing the joystick lock lever in
locks the joystick while pulling it
outward unlocks the joystick as
shown in the gure.
Do not leave the tractor with
the boom off the ground in any
circumstances. If it is neces-
sary, lock the joystick.
When the j oy stick l ever i s
not in use, lock it since the
implement can fall down if the
lever is operated accidently.
If the boom or bucket is not oper-
ating, properly, lower the bucket
onto the ground, stop the engine
and move the joystick lever to
remove all hydraulic pressure in
the system. Then, check all the
hydraulic connections and recon-
nect them correctly.
Before connecting or disconnect-
ing the hydraulic hose coupling
for the loader, lower the boom
onto the ground, stop the en-
gine, and move the joystick lever
front and back, left and right for
several times to remove residual
pressure in the hydraulic hose.
IMPORTANT
WARNING
To Next Page
Loading...
