Product Overview
On/Off Light
Light Status Cause Action/Solution
On/Off light is off. The printer is turned off. Press On/Off to turn the printer on.
The printer does not have power
applied.
Ensure that the power cord is
properly plugged into the back of the
printer.
The printer needs attention.
Disconnect the power for 5 seconds
and reconnect the power. If the
problem persists, contact Kodak for
assistance.
The On/Off light is
steady green.
The printer is properly powered
up, on, and ready.
None. You may start printing,
copying, scanning, or other tasks.
The On/Off light is
flashing green.
The printer is busy.
None. Normal operation when
performing a print, copy, scan, or
other job request.
The printer is initializing.
None. Please wait and allow the
printer to complete the initialization
process (about 30 seconds). If the
flashing green persists, you may
have an issue with the printer. Visit
www.Kodak.com
for additional
troubleshooting steps or contact your
local Kodak Call Center.
The printer is calibrating.
None. Please wait and allow the
printer to complete the calibration
process (about 5 minutes).
The printer is preparing to print,
copy, or scan.
None
The On/Off light is
steady amber.
The printer has detected an error
condition.
Disconnect power for 5 seconds and
reconnect power. If the condition
persists, check the Quantity display
for additional codes. Contact Kodak
for assistance.
Check the status monitor (Windows)
on your computer for a message.
The On/Off light is a
flashing red.
The printer has detected an error
condition that needs your
attention.
Please check for other lights and
follow the instruction for that light.
Check the status monitor (Windows)
on your computer for a message.
User Guide 7
To Next Page
Loading...
