12 AT000115-02
“Plate Carrier Stuck Please Call Service”
Scenario
Plate Carrier (Screen Carrier) gets stuck when the user inserts the cassette and locks it into the Reader. As a result
the CR Reader gets an alarm that the Z0 Sensor (J505) didn’t change its position from “0” to “1”.
Hardware and Software Response
[1] The plate (screen) is not loaded.
[2] The cassette is ejected.
[3] CR Reader operating status returns to “Insert Cassette”.
Fix
User Response:
[1] Click [OK]; the CR Reader performs the unload cassette operation.
[2] Does the error message, “Z0 Sensor at wrong state” appear?
Service Response
[1] Remove the CR Reader cover.
[2] Does the Screen Carriage continue to get stuck while crossing the drum?
Yes No
a. CR operating status changes to “State stalled.”
b. Reset the CR Reader by turning it OFF and ON again
c. Does the message, “Z0 Sensor at wrong state” appear
again?
Continue using the CR
Reader
Yes No
Contact Service Continue using the CR Reader
Yes No
a. Manually move the Screen Carrier to its homing position.
b. Turn the CR Reader ON.
c. Insert a cassette and see if one of the sensors is interfering
with the Screen Carrier movement.
Check /replace the Z0 J505 Sensor by
means of “
Sensors Tests” on Page 53.
Yes No
Adjust the sensor position. Check for mechanical issues,
the carrier track might be too
narrow and cause the carrier to
stick.
To Next Page
Loading...
