Software Error Messages
AT000115-02 27
Setting Screen in Kodak Technician Interface
Error no. Error Message Text Possible Reason and Solution
1 Failed opening the file. Failed to open the files that were requested for
updating. (FW = iic & FPGA = rpd)
2 The file is in a wrong format. If the selected file for import operation is in a wrong
format (for example: not an XML file or switching
between Anatoms and ScannerSettings).
3 Barcode CR Reader fails. (applicable only if LLI
application is installed)
Check Barcode operation.
4 Value is out of range. Can happen during calibration. Recalibrate.
To Next Page
Loading...
