MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series Chapter 7
Operation Manual Graphic Displays
93142122-07 7-7
stationary. To clear all mark data, press HL OFF key at this state.
(5) Move the Joystick up or down to highlight the number shown right to the words
POSITION NUMBER and press the ENT key. The number will blink.
(6) Select a desired mark by pressing a numeric key (0 - 9)
(7) Use the N/S/E/W and numeric keys (0 - 9) to enter the latitude and longitude
coordinates. If a correction is needed, move the Joystick left or right to highlight
the part for correction and enter new data.
(8) Press the ENT key to fix the entry. The blinking alphanumeric data will become
stationary. To clear the mark data, press HL OFF key at this state.
(9) To continue the entry of position data for other position numbers or change the
data, repeat the step (5) and after.
To Next Page
Loading...