bizhub PRESS 1250/1052 6-17
6.2 Separate Scan Mode
6
6.2 Separate Scan Mode
The ADF accepts only 100 sheets at a time, however, the Separate Scan mode allows you to handle the orig-
inal that exceeds 100 sheets as a single job.
The multiple original scanned from the original glass, or both from the ADF and from the original glass, can
also be combined into a single job.
0 Separate Scan mode is necessarily used and operates automatically to make duplex copies using orig-
inal glass. Also, setting application functions such as Insert Image, Book Copy, Program Job, or Reg-
ister Image of Registered Overlay automatically sets the Separate Scan mode.
NOTICE
Note that the maximum number of the original available in the ADF does not change in this mode. Do not
load more than 100 original sheets or above the limit mark [,]. Otherwise, the original may be misfed or dam-
aged.
1 Position the original.
Using the original glass, place the first page face down on the
original glass.
Using the ADF, load the original arranged in page order with
page one on the top.
2 Press [COPY] tab to display the Copy Screen.
3 Set the desired copy conditions, then select [Separate Scan].
The Separate Scan mode will be activated. If this key is already highlighted, the [Separate Scan] mode
has been activated automatically due to some copy selection.
To Next Page
Loading...
Need help?
General
