27
Card Removal
1. Open the battery/card cover.
2. If you gently push in on the card, the
lock will release and the card will come
out a little. Then carefully draw the card
out.
3. Again, close the battery/card cover.
Warning! Insert or remove cards only after making sure that absolutely
all power is OFF as indicated by the viewfinder LED being
off.
While the card is being accessed, or an image is being
processed, the LCD monitor will show “Now COPY…”, etc.,
and the green LED will come on.
If you open the battery/card cover while the green LED is
lit, image processing may be interrupted or hindered.
While the green LED is still lit, make sure that you DO
NOT open the battery/card cover.
• Also, it is possible to insert and use two cards simultaneously, such as an
SD memory card (or multi-media card) and a Memory Stick.
When 2 cards are inserted at the same time, recording priority is given to
the card that was used first. This priority can be changed in the menu
settings (p.60).
Inserting/Removing Cards (Cont’d)
To Next Page
Loading...
Need help?
General
