Grandstage X
-
Panel description and functions
11
11 / buttons
Use these buttons to move the cursor () up and down in the display. You can edit the parameters
selected with the cursor on the display by using the value dial or the +/- buttons.
12 Display
Shows the program name and parameter values while in Edit mode.
13 Function buttons
These buttons recall the functions shown in the display.
14 Value dial and +/- buttons
Use these controls to edit the value of the parameter that’s selected by the cursor.
15 EXIT button
This is used to cancel a favorite write operation, and can also be used to exit the Panel Lock function,
edit mode, navigate out of the system settings and so on.
16 ENTER button
Press this to access the edit page and to execute commands.
As with Damper Pedal Calibration in SYSTEM, when “>” is shown to the right of the parameter name
that’s selected in the display and you press the ENTER button, you can access the next page farther
down. When [OK] or [Cancel] is shown onscreen, you can press the ENTER button as a shortcut for
OK.
17 SOUND SELECT (Sound Select section)
Use these buttons to select the programs from categories, which are assigned to the MAIN, LAYER
and SPLIT parts on the Grandstage X. You can also use these to save the sounds you’ve created and
then select them as favorites.
Buttons 1–10
The sounds on the Grandstage X are divided into 10 categories.
To select a program, first use buttons 1–10 to specify the category of sound you want to select, and
then choose a sound program you like from that category.
→ Selecting sounds
To Next Page
Loading...
