Korg Grandstage X - Adjusting the Sound; Two Wheels Plus SW1 and SW2

Grandstage X - Selecting and playing sounds
32
Adjusting the sound
| Two wheels plus SW1 and SW2
The controls on the left side of the front panel include the pitch bend wheel, modulation wheel, SW1
and SW2 buttons (from left to right). These controllers are configured to make effective use of each
sound. See the “Sound Name List” for details.
Tip: You can turn the respective controllers on/off (enabled/disabled) for each layered and split sound.
→ Program parameters
Pitch bend wheel
This is mainly used to control the pitch of notes played. Move the wheel up to raise the pitch, and
move the wheel down to lower the pitch. This is sometimes used to change the effect speed for piano
sounds, or the rotary speaker speed for organ sounds.
Modulation wheel
This is mainly used to control effects like vibrato or tremolo that are applied to the sound. Moving the
wheel up applies the effect that’s set for the respective sound.
SW1, SW2
These buttons are mainly used to turn the sound variations and effects on/off.
Note: The on and off settings for SW1 and SW2 can be saved as favorites.