Korg Grandstage X - File

Grandstage X - System settings
79
1 Press the SYSTEM button to enter system settings.
2 Press the function button corresponding to “SYSTEM” below the display to access the SYSTEM
page.
3 Use the / buttons to select “Factory Reset”, and press the ENTER button.
“This will reset all settings and favorites. Press [OK] to start.” is shown in the display.
Note: To cancel the factory reset operation, press the rightmost function button to exit.
4 Press the function button below the display that corresponds to “OK”, which is shown at the
bottom of the display.
When the reset is completed, the message “Successfully done.” appears.
5 Press the rightmost function button to exit the system settings.
| FILE
Saving favorite data (SAVE Favorites)
This shows how to save the 100 favorites that have been edited on or written to the Grandstage X to
an SD card.
For instance, you could save the favorites that you created in your home studio to an SD card, and
then reload these favorites in the studio or onstage to the Grandstage X, which will bring back the
favorite sounds you created in your home studio. Also, by managing your favorites that might differ
for each live performance or project as a .FAV file, you can instantly prepare a “set” of the favorites
that you need each time.
1 Insert an SD card into the SD card slot of the Grandstage X.
2 Press the SYSTEM button to enter system settings.
3 Press the rightmost function button to access the FILE page.
4 Use the  button to select “SAVE Favorites”, and press the ENTER button.
A screen for setting the filename is shown in the display.
Note: To cancel the save operation, press the SYSTEM or EXIT button to exit.
Note: If an SD card is not available in the SD card slot, the message “NO VALID MEDIA” appears in the display, and
the save operation is canceled. If this happens, press the EXIT button, insert an SD card and then press the
ENTER button again.
5 Press the / buttons to select the character position, and use the value dial or the +/- buttons
to select the characters for the filename.
“GSX0001” is shown by default. Filenames can be up to seven characters long.
Note: To cancel the filename renaming operation, press the EXIT button. The display returns to the FILE page.
6 Once you’ve set the filename, press the rightmost function button to save.
After the save operation is done, the word “DONE” is shown in the display.
Note: If a file with the same name already exists where the file will be saved on the SD card, the message “FILE
OVERWRITE” will be shown on the middle row of the display. To overwrite and save the file, press the second
function button from the right. To cancel overwriting and saving the file, press the rightmost function button.
The display returns to the FILE page. Edit the filename again, and then follow step 4 to save.
7 Press the SYSTEM or EXIT button to finish the system settings.
Storage media that can be used
This instrument is compatible with SD cards in FAT16 or FAT32 format.