Grandstage X
-
System settings
73
System setting parameters
|
BASIC
Master Tune (Tune)
Sets the tuning for the entire keyboard.
Tuning can be set in cents (1 semitone=100 cents), within a range of ±50 cents
(427.47...440...452.89 Hz). The default setting is “+0”, or 440 Hz (the frequency for A4).
MIDI local control (Local Control)
Set whether the Grandstage X’s own keyboard, wheels and other controls will control the
Grandstage X’s sound engine (On), or whether the Grandstage X’s own keyboard will only be used to
output MIDI messages to external devices, without controlling the Grandstage X’s sound engine (Off).
Normally, this is “On” when playing the Grandstage X by itself.
The default setting is “On”.
→ MIDI local settings when connecting to an external MIDI sequencer or computer
Velocity Curve (Velocity Curve)
This sets how the volume and tone will be changed in response to the keyboard velocity (how hard
the keys are played) on the Grandstage X.
The default setting is “4 (Normal)”.
1 (Heavy), 2, 3: These curves produce an effect when you play strongly.
4 (Normal): This is the typical curve.
5, 6: These curves let you produce dynamic change without having to play very hard.
7: This curve provides a flat effect when playing softly.
8 (Light): This curve provides an even flatter effect.
9 (Wide): This curve produces an even softer response when you play softly, compared to the stan-
dard curve #4.
Convert Position (Convert Pos.)
This specifies the position at which the transposition and velocity curve will apply. The setting has an
effect on MIDI data that is transmitted and received.
Note:
The transpose value is set from the TRANSPOSE button .
→ Transposing (changing the key)
Pre-MIDI: Transposes and applies the velocity curve to data immediately after it is outputted from
the keyboard.
To Next Page
Loading...
