Grandstage X
-
System settings
75
|
CTRL (CONTROLLERS)
Foot - Pedal (foot pedal functions)
This sets the functions that will be controlled when a foot pedal (such as the XVP-20 or EXP-2, sold
separately) is connected to the FOOT CONTROLLERS PEDAL jack on the rear panel. This allows the
volume and effects to be controlled.
The default setting is “Expression (#11)”.
Off: The connected pedal does not function.
Expression (#11): Controls the expression pedal. Use this setting to control the output volume of the
MAIN, LAYER and SPLIT parts. The value of the MIDI Volume (CC#7) message and the expression are
multiplied to get the actual volume. (*1) (*2) Some programs operate in a special way. For programs
with the words “Pedal Wah” in the name, the pedal controls the pedal wah effect within the program,
not the volume.
Volume (CC#7): Used to control the volume. Use this setting to control the output volume of the
MAIN, LAYER and SPLIT parts. (*1)
Master Volume: Sends a master volume message (universal exclusive message) to control the final
volume of all sound source outputs, including the REVERB/DELAY section and the equalizer. (*3)
Mod Wheel (#1): Lets you control the modulation wheel effect of the Grandstage X by pedal.
MIDI CC#0...#95, #102... #119: Outputs the MIDI control change message that is set. If the
Grandstage X supports this control change setting, the effect is applied.
*1: Controls the volume of the REVERB/DELAY section and the equalizer prior to input.
*2: On the CX-3 type organ programs, this controls the volume before the rotary speaker input. Recre-
ates the effect of an expression pedal used with drawbar organs. The expression pedal effect can be
recreated in the same way for VOX organ and electric organ programs as well.
*3: The effects are applied apart from the VOLUME slider.
Foot - Switch (foot switch functions)
This sets the functions that will be controlled when a foot switch (PS-1 or PS-3, sold separately) is con-
nected to the FOOT CONTROLLERS SWITCH jack on the rear panel. This allows you to switch between
favorites, as well as control sounds and effects.
The default setting is “SW2 (CC#81)”.
Off: The connected pedal does not function.
SW 1 (CC#80): This controls the SW1 button effect with the foot switch.
SW 2 (CC#81): This controls the SW2 button effect with the foot switch.
Soft (CC#67): Turns the soft pedal effect on or off.
Program Up: Selects the next program number with the foot switch.
Program Down: Selects the previous program number with the foot switch.
Favorite Up: Selects the next favorite number using a foot switch. At the same time, this sends a
program change message.
Favorite Down: Selects the previous favorite number using a foot switch. At the same time, this
sends a program change message.
MIDI CC#0...#95, #102...#119: Outputs the MIDI control change message that’s set. If the
Grandstage X supports this control setting, the effect will be applied.
To Next Page
Loading...
