Korg Grandstage X - Page 76

Grandstage X - System settings
76
Part slider operation mode (Part Slider Mode)
This configures what happens when you operate the sliders in the PART CONTROL section.
Scale: The slider position is the current parameter value. For the parameter range when you move
the slider, the current value decreases when you move the slider down, and the current value
increases when you move the slider up. When you move the slider all the way up or down, the range is
reset. Refer to the diagram below.
Jump: When you move the slider, the parameter value instantly jumps to the value corresponding to
that position.
Note: The default setting is “Scale”.
Calibrating the pedal
Calibrating the damper pedal (Damper Pedal Calibration)
Calibrate the damper pedal (such as the DS-1H) that is connected to the DAMPER jack. This will adjust
the half-damper variable range.
Tip: The calibration set here will be stored in memory until you perform the calibration again.
1 Connect the damper pedal to the Grandstage X.
→ Foot controllers
2 Lift your foot off the damper pedal.
3 Press the SYSTEM button, use the / buttons to select “Damper Pedal Calibration” and press
the ENTER button.
“Damper Pedal Calibration [Press Pedal]” appears on the display.
Note: If you wish to cancel the calibration while “[Press Pedal]” is shown, press the SYSTEM or EXIT button to exit.
4 Press the damper pedal down all the way until it stops, and then lift your foot off the pedal.
Note: If nothing happens even when you press the pedal, the pedal may not be connected properly to the DAMPER
jack. Check the connections.
5 When the calibration is completed, the word “Completed” appears in the display.
Note: If calibration was not correctly completed, the display does not change. Do step 4 once more.
6 Press the EXIT button.