Grandstage X
-
System settings
77
Calibrating the foot pedal (Foot Pedal Calibration)
Calibrate the expression pedal (such as the XVP-20 or EXP-2, sold separately) that is connected to the
PEDAL jack. This will adjust the pedal’s variable range.
Tip:
The calibration set here will be stored in memory until you perform the calibration again.
1 Connect the expression pedal to the Grandstage X.
→ Foot controllers
2 Tilt the expression pedal all the way down towards you.
3 Press the SYSTEM button, use the / buttons to select “Foot Pedal Calibration” and press the
ENTER button.
“Expression Calibration [Press Pedal]” appears on the display.
Note:
If you wish to cancel the calibration while “Expression Calibration [Press Pedal]” is shown, press the SYSTEM
or EXIT button to exit.
4 Press the expression pedal upward all the way until it stops, and then bring the pedal all the way
down.
Note:
If nothing happens even when you press the pedal, the pedal may not be connected properly to the PEDAL
jack. Check the connections.
5 When the calibration is completed, the word “Completed” appears in the display.
Note:
If calibration was not correctly completed, the display does not change. Do step 4 once more.
6 Press the EXIT button.
Calibrating the foot switch (Foot Switch Calibration)
Calibrate the switch-type foot pedal (such as the PS-1 or PS-3, sold separately) that is connected to
the SWITCH jack. This will adjust the pedal’s variable range.
Tip:
The calibration set here will be stored in memory until you perform the calibration again.
1 Connect the switch-type foot pedal to the Grandstage X.
→ Foot controllers
2 Lift your foot off the foot pedal.
3 Press the SYSTEM button, use the / buttons to select “Foot Switch Calibration” and press the
ENTER button.
“Foot Switch Calibration [Press Pedal]” appears on the display.
Note:
If you wish to cancel the calibration while “Foot Switch Calibration [Press Pedal]” is shown, press the SYS-
TEM or EXIT button to exit.
4 Press the foot pedal down all the way until it stops, and then lift your foot off the pedal.
Note:
If nothing happens even when you press the pedal, the pedal may not be connected properly to the SWITCH
jack. Check the connections.
5 When the calibration is completed, the word “Completed” appears in the display.
Note:
If calibration was not correctly completed, the display does not change. Do step 4 once more.
6 Press the EXIT button.
To Next Page
Loading...
