Korg Grandstage X - Making the Chords Progress Automatically for a Virtual Session with Drums and Bass

Grandstage X - Selecting and playing sounds
41
| Making the chords progress automatically for a virtual
session with drums and bass
1 Press the CHORD PROGRESSION button to turn it ON (the button lights up).
2 Press the SETUP button to set the rhythm style and tempo. (You can also do this while the rhythm
plays.)
Press the / buttons to select a parameter, and use the value dial or the +/- buttons to set the
value.
3 Press the function button corresponding to “CHORDPRG” at the bottom right of the display.
4 Use the  and  buttons to the left of the display, or the value dial (or even the +/- buttons) to
set the “Chord Progression” (chord progression pattern) and “Key” (the key used for the chord
progression).
If you select “Setup” and press the ENTER button, you can select by seeing the chord names
while you play.
5 Press the / button (the button lights up).
The drums and bass start playing. The bass part follows along automatically with the chords
shown.
6 To stop the rhythm, press the / button again (the button goes dark).
Tip: Press the BASS MUTE button to silence the bass sound in the rhythm and hear only the drums.
Tip: You can quickly set the tempo by pressing the TEMPO button two or more times at the desired tempo.
Tip: Press the KEY button (the “KEY” setting is shown in the display) and then play a note on the keyboard to
instantly change the key of the chord progression.