Korg Grandstage X - Audio in Parameters

Grandstage X - Audio In settings
56
Audio In parameters
Audio In: On, Off
Enables/disables the Audio In.
When this is set to “On”, the audio signal that’s input from the AUDIO IN L/MONO and R jacks is out-
put from the AUDIO OUTPUT L/MONO and R jacks, at a level that you set using the Output Level
parameter.
This setting works in tandem with the AUDIO IN button on the front panel.
Output Level: 0...100
Sets the output level.
Reverb Send: 0...100
Specifies the amount of signal to send to reverb that’s input from the AUDIO IN L/MONO and R jacks.
IFX Setup:
Selects the insert effect to use.
Off
The insert effect is not used.
Dyna Compressor
This effect compresses the input signal, giving it a punchier sound to make each note more uniform
and clear.
Sensitivity: 1...100
Adjusts the sensitivity.
Attack: 1.00...25.00 [ms]
Adjusts the attack strength.
Output Level: -Inf, -84.9...0.0 [dB]
Adjusts the output level of the compressor.
Exciter/Enhancer
This uses an exciter effect to add dynamics for better sonic definition, combined with an enhancer
effect to add spaciousness and presence.
Emphasis Freq: 3000...24000 [Hz]
Sets the frequency emphasized by the exciter.
Blend: -100...+100
Adjusts the depth of the exciter effect.
Enhancer Depth: 0...100
Adjusts the depth of the enhancer effect.
Low EQ Gain: -15.0...+15.0 [dB]
Sets the gain for the low-range equalizer.
High EQ Gain: -15.0...+15.0 [dB]
Sets the gain for the high-range equalizer.