Grandstage X
-
Audio In settings
57
Isolator
This is a stereo effect that divides the input signal into low, mid- and high-frequency bands, letting
you control the volume for each band. For instance, you can use this to cut or boost the sound of the
kick, snare and hi-hat in the drum kit separately.
Preset: Radio, Scooper Mid EQ, No High End, No Low End
Selects the frequency band to extract.
- Radio: Extracts only the frequency bands that are characteristic of audio heard over the radio.
- Scooper Mid EQ: Extracts only the midrange frequency band.
- No High End: Cuts and extracts the high-range frequencies.
- No Low End: Cuts and extracts the low-range frequencies.
Low Gain: -Inf,-84.9...+12.0 [dB]
Sets the gain for the low-range frequency band.
Mid Gain: -Inf,-84.9...+12.0 [dB]
Sets the gain for the midrange frequency band.
High Gain: -Inf,-84.9...+12.0 [dB]
Sets the gain for the high-range frequency band.
Multi-Mode Filter
This is a four-type multi-mode filter featuring low-pass, high-pass, bandpass and band reject settings.
Preset: LPF, HPF, BPF, BRF
Selects the filter type.
- LPF: low-pass filter
- HPF: high-pass filter
- BPF: bandpass filter
- BRF: band reject filter
Frequency: 0...100
Sets the cutoff frequency (center frequency).
Resonance: 0...100
Sets the amount of filter resonance.
Drive Gain: 0.0...18.0 [dB]
Sets the amount of driver distortion.
Mastering Limiter
This is a stereo limiter that’s optimized for use in song mastering and so on.
Threshold: -30.0...0.0 [dB]
Sets the signal level at which compression is applied.
OutCeiling: -30.0...0.0 [dB]
Sets the output gain for the limiter.
Release: 0.65...1000.00 [ms]
Sets the release time for the limiter.
To Next Page
Loading...
