Grandstage X
-
Panel description and functions
15
Rear panel
1 AUDIO OUTPUT
You can connect powered monitors, a stereo amp, mixer, or multi-track recorder to these jacks.
Headphones jack
Here you can connect a set of headphones equipped with a 1/4" (ø6.3 mm) stereo phone-plug. This
jack will output the same signals as the AUDIO OUTPUT. Use the VOLUME slider to adjust the volume.
The audio output from other jacks is not turned off when you connect headphones to the headphones
jack.
→ Connecting the headphones
L/MONO, R jack
These are 6.3 mm TS (unbalanced tip-sleeve) phone jacks for outputting audio.
Use the VOLUME slider to adjust the volume.
If you’re using a stereo connection, connect to both L/MONO and R jacks.
If you’re using a monaural connection, connect to the L/MONO jack. This jack is used for devices that
only have a mono input.
LEFT, RIGHT jack
These are XLR (balanced) jacks for stereo audio output.
Use the VOLUME slider to adjust the volume.
GND-LIFT switch
Normally, this switch should be set to GND. When the switch is set to LIFT, the GND of the LEFT and
RIGHT jacks will be separated from the ground of the instrument. If ground loop or similar noise
occurs, the LIFT setting may resolve the problem.
→ Connecting audio devices
2 AUDIO INPUT
The Grandstage X features audio input jacks for connecting a mic, external audio equipment, other
instruments and so on. You can mix this audio input with the sound of the Grandstage X and send this
sound to the AUDIO OUTPUT jacks.
If you connect the Grandstage X’s LEFT and RIGHT jacks (XLR) to a mixer or similar device,
be sure to turn off the phantom power of that device. The Grandstage X might be damaged if
you fail to do so.
To Next Page
Loading...
