Grandstage X
-
Selecting and playing sounds
33
|
Other buttons and sliders
TRANSPOSE button
While holding down the TRANSPOSE button, press a key from C3 to B3, or from C#4 to C5 on the key-
board.
This shifts the key within a range of -12 to -1 semitones, or +1 to +12 semitones.
→ Transposing (changing the key)
SWAP SPLIT button
While playing in split mode, you can swap programs for the upper part (the part of the keyboard to
the right of the split point) with the lower part (the part of the keyboard to the left of the split point)
by pressing the SWAP SPLIT button.
PANEL LOCK button
When you long-press this button, the button blinks and the majority of the buttons, sliders and knobs
on the operation panel are disabled. This prevents the sound from being accidentally changed while
you’re playing. Press the button again to release the panel lock.
→ Panel lock
SYSTEM button
The settings that can be made here include overall settings for the Grandstage X including master
tune, MIDI, controller functions and so on.
→ System settings
AUDIO IN button
When this button is on, you can mix the sound of the device or equipment connected to the AUDIO
INPUT jacks on the rear panel with the sound of the Grandstage X. This lets you smoothly turn the
mic’s audio on/off without touching the mic itself, when you’re singing while playing, talking to the
audience between songs and so on.
→ AUDIO IN function
→ Audio In settings
To Next Page
Loading...
