Grandstage X
-
Appendices
96
Troubleshooting
Power does not turn on.
• Is the power cord connected to an AC outlet?
• Have you pressed the power button?
Power won’t turn off.
• Did you hold down the power button for a while?
Power turns off.
• The auto power off function may be enabled.
No sound when you play the keyboard.
• Is your powered monitor system or headphones connected to the correct jack(s)?
• Is the connected monitor system powered-on, and is the volume raised?
• The VOLUME slider might be at the minimum setting.
• Is Local Control turned on?
• The sliders for each section in PART CONTROL might be at the minimum setting.
• The volume of the pedal connected to the FOOT CONTROLLERS PEDAL jack might be at the
minimum setting.
The sound will not stop.
• Are the settings for the damper pedal correct? Use the damper pedal calibration function to
adjust the polarity and half-damper variable range of the pedal.
The sound seems to be doubled.
• If you are using an external MIDI device or a DAW, check whether the local control setting of
the Granadstage X is turned OFF.
The sound is distorted.
• Are the inputs of the mixer, powered monitor speakers and so on being overloaded?
Use the VOLUME slider on the Grandstage X to adjust the output level, as well as the input
gains and mixer levels.
Chords cannot be played on the keyboard.
• On some programs such as monophonic synthesizer sounds, you will not be able to play
chords. This is not a malfunction.
The pitch doesn’t sound right.
• Is the transpose function set correctly?
• Has “Tune” in the system settings been set correctly, as well as the program’s octave and tune
edit parameters?
Is panel lock on?
• Panel lock might be on (the PANEL LOCK button blinks in this case).
The equalizer, key touch and reverb/delay effects aren’t working or can’t be
controlled.
• Panel lock might be on (the PANEL LOCK button blinks in this case).
• The KEY TOUCH, EQ or REVERB/DELAY buttons might be off (dark).
To Next Page
Loading...
