Korg Grandstage X - Connecting and Playing with a Sound Source

Grandstage X - Selecting and playing sounds
39
3 Press the / buttons to select “Reverb Send”, and use the value dial or the +/- buttons to set
the reverb send level.
The audio signal is sent to the REVERB/DELAY section represented on the front panel, at the
send level that you set here. Use the buttons and slider in the REVERB/DELAY section to adjust
the effect type and depth.
→ Reverb/delay settings
Playing the Grandstage X
1 Sing or vocalize into the mic while you’re playing.
Disconnecting the mic
1 Press the AUDIO IN button on the front panel to deactivate the Audio In function (the button goes
dark).
2 Unplug the mic.
| Connecting and playing with a sound source
Connecting a sound source
1 Follow the steps in “Connecting a mic” to connect a sound source.
If you’re using a sound source with stereo outputs, connect the outputs to the AUDIO INPUT L/
MONO and R jacks on the Grandstage X.
→ Connecting a mic
2 Set the MIC/LINE switch on the rear panel to the “LINE” position.
3 Press the AUDIO IN button on the front panel to activate the Audio In function.
The AUDIO IN button lights up.
4 Play back music on your music player or other device.
5 Adjust the volume with the LEVEL knob while checking the output audio via AUDIO OUTPUT.
You should adjust the audio volume to avoid distortion.
Setting the Audio In parameters
1 Press the AUDIO IN and SYSTEM buttons on the front panel at the same time to set the output
level and configure the effects.
→ Configuring the mic output level and effects
Note: To adjust the volume balance between the mic and the programs, use this Output Level setting and the slid-
ers in the PART CONTROL section.
Play the Grandstage X
1 Play along with the sound source.
Disconnecting the sound source
1 Press the AUDIO IN button on the front panel to deactivate the Audio In function (the button goes
dark).
2 Unplug the sound source.