Korg Grandstage X - Page 66

Grandstage X - Setting the rhythm
66
Tip: You can change the type and key even while the accompaniment is playing. If you’ve edited
these settings, these changes are applied at the beginning of the measure.
5 To stop playing, press the / button.
The / button goes dark, and the accompaniment stops.
6 Press the CHORD PROGRESSION button to turn the chord progression function off.
User settings for the chord progression (user chord progression)
By changing the accompaniment (“Chord Progression”) to a type from User 1 to User 20, you can cre-
ate your own chord progressions as you like, with chord changes every two beats up to 16 measures
in length.
1 Set “Type” in the CHORD PROGRESSION page to a type from “User 1” to “User 20”.
2 Press the function button corresponding to “USER EDIT”, located below the display.
The user chord progression edit screen is shown.
3 Set the number of measures using the “Length” parameter.
You can set the length from one to 16 measures.
4 Press the / buttons to select the step to set, and use the value dial or the +/- buttons to select
the chord root note (C–B). To set a chord type such as minor or major 7th, or to set a repeat
symbol, use the value dial or the +/- buttons while holding down the ENTER button.
You can set two chords in one measure.