Grandstage X
-
MIDI settings
89
You can use the sound control messages (CC#0–95 and CC#102–119) to control and make changes to
the sound of the Grandstage X.
Frequently-used control change messages
Here’s a list of some control change messages supported by the Grandstage X that are typically used.
Note:
The functions mentioned here are described in their factory default state.
Applying modulation using the modulation wheel
CC#1: Modulation Depth [Bn, 01, vv]
(standard: modulation wheel)
Controls the vibrato effect applied to the sound.
Modulation depth messages are transmitted when you operate the modulation wheel on the
Grandstage X. A value of “0” is transmitted when the wheel is all the way down (minimum position).
When this message is received, an effect similar to operating the modulation wheel on the
Grandstage X is applied.
Volume control
CC#11: Expression [Bn,0B, vv]
Adjusts the volume of the program. Controls the output volume for the MAIN, LAYER and SPLIT
parts.
Note:
On the CX-3 type organ programs, this controls the volume before the rotary speaker input. Recreates the
effect of an expression pedal used with drawbar organs. The expression pedal effect can be recreated in the
same way for VOX organ and electric organ programs as well.
Note:
This functions differently from normal in some programs. For programs that include the words “Pedal Wah”,
the pedal controls the pedal wah effect within the program, not the volume.
When you assign “Expression (CC#11)” to the Foot Pedal function in system settings, you can operate
the pedal to transmit expression control change messages, which changes the volume. When this
message is received, an effect similar to operating the pedal on the Grandstage X is applied.
CC#7: Volume [Bn, 07, vv]
Adjusts the volume of the program. This controls the output volume of the MAIN, LAYER and SPLIT
parts.
When you assign “Volume (CC#7)” to the Foot Pedal function in system settings, you can operate the
pedal to transmit volume control change messages, which changes the volume. When this message is
received, an effect similar to operating the pedal on the Grandstage X is applied.
Note:
The program volume is set as a combination of the LEVEL knob value, the volume message value and the
expression message value.
Note:
When you use a universal system exclusive message (master volume) this controls the volume of all outputs,
including the REVERB/DELAY section and the equalizer.
Panpot (stereo position) control
CC#10: Panpot [Bn, 0A, vv]
Controls the position (pan) in the stereo field. This controls the panpot of the output from the MAIN,
LAYER and SPLIT parts.
When you assign “CC#10” to the Foot Pedal function in system settings, you can operate the pedal to
transmit panpot messages, which changes the panning.
When this message is received, the actual stereo (pan) position of the sound changes (left to center
to right), corresponding to the values (0–64–127).
To Next Page
Loading...
