18
Rear panel
ASSIGN. PDL/SW
Use this port to connect a continuous- or foot-
switch-type pedal, like the Korg EXP2 or XVP10.
To program it, see “Pedal/Footswitch” on
page 206. By default, it controls Glide.
7 PHONES
Connect a pair of headphones to this output. You can use head-
phones with an impedance of 16-200Ω (50Ω suggested). Use a
headphone splitter to connect more than one pair of head-
phones.
Note: When inserting a jack into this connector, the speakers are
automatically turned off.
8 OUTPUT (L/MONO, RIGHT)
Use these unbalanced connectors to send the audio signal
(sound) to a mixer, a PA system, a set of powered monitors, or
your hi-fi system. Connect only the L/MONO jack to output the
signal in mono. Set the output level with the MASTER VOLUME
slider.
Note: This MASTER VOLUME slider does not control the signal
entering the AUDIO INPUTs (see below).
9 INPUT (L/MONO, RIGHT)
Use these unbalanced connectors to input another keyboard/
synthesizer, a CD or MP3 player, or a mixer’s (non-powered)
output. The signal goes directly to the final mix.
0 DC 12 V power adapter connector
Plug the supplied power adapter into this connector.
A Cable holder
Fix the power cable to this hook, to avoid cable jamming.
Pa500-110UM-ENG.book Page 18 Friday, March 28, 2008 11:12 AM
To Next Page
Loading...
