43
Selecting and saving Performances
Saving your settings to a Performance
Quick Guide
4 Select a Bank and Performance location in memory, where you would
like to save the Performance.
5 When you have changed the name to the Performance, and selected the
target location, press OK to save the Performance to memory (or cancel
to stop the operation).
Warning: Saving a
Performance to an
already used location
overwrites any existing
data at that location.
The old data are lost.
Make a backup of all
your important data.
To select the target Bank and
Performance location, select
the Bank and Performance
parameters, and use the
TEMPO/VALUE dial.
A)
B)
The selected Perfor-
mance location is
highlighted. Press a
Performance’s name
to select it.
Press one of the side tabs to
select a different Performance
bank.
Press one of the lower tabs to
select a different Performance
page.
or…
Note: A Performance
can be saved to an
‘Empty’ location. An
‘Empty’ locations
currently contains
no data.
Set of banks. [1/8] corresponds to the top
row of Performances on the control panel,
[9/16] to the lower row.
!
Pa500-110UM-ENG.book Page 43 Friday, March 28, 2008 11:12 AM
To Next Page
Loading...
