Korg RK-100S 2 - Power save function; Battery type and remaining power; Auto power off function

Shift functions
17
Power save function
WhentheRK-100S2isbeingpoweredbybaeries,the
powersavefunctionwillautomaticallyturnothedisplay
andLEDsdependingontheremainingbaerypowerlevel.
Note: Withthefactoryseings,thepowersavefunction
isO.
1. Hold down the SHIFT button and press the
favorites F button.
Theseingforthepowersave
function appears in the display.
2. Use the OCTAVE +/- buttons or
the SOUND/FAVORITE BANK
lever to select the setting.
on: Enabled
oFF: Disabled
3. Press the SHIFT button to exit the shift function.
Battery type and remaining power
Thisallowsyoutoselectthetypeofbaerytobeused.
Inaddition,theremainingpowerlevelofthebaeries
currently being used can be checked.
 Iftheselectedtypeisdierentfromthetypeof
baeriesbeingused,theremainingamountof
baerypowerwillnotbecorrectlyindicated.
1. Hold down the SHIFT button and press the
favorites G button.
Thebaerytypeappearsinthe
display.
Theeightfavoritesbuons
(A–H)arelituptoindicatethe
remainingbaerypowerlevel.
Thenumberoflitbuonsmay
be lower depending on the
baerycapacity.
Newbaeries:Allbuonslit
Lowremainingbaerypowerlevel:OnlybuonAlit
Timetoreplacebaeries:BuonAblinks
 WhentheACadapterisconnected,allbuonsare
turnedo.
2. Use the OCTAVE +/- buttons or the SOUND/
FAVORITE BANK lever to select the battery type.
AL.: Alkalinebaeries
ni.H: Nickel-metalhydridebaeries
3. Press the SHIFT button to exit the shift function.
Auto power o function
TheRK-100S2isequippedwithanautopowero
function. With this function, the RK-100S 2 automatically
turnso(lowpowerconsumptionstate)ifthereisnouse
for approximately four hours.
IftheRK-100S2hasbeenautomaticallyturnedowith
theautopowerofunction,itcannotbeturnedonby
pressingabuonorkeyboardkeyorusingaribbon
controller. Turn the RK-100S 2 on again.
Note: Withthefactoryseings,theautopowerofunc-
tion is enabled.
1. Hold down the SHIFT button and press the
favorites H button.
Theseingfortheautopower
ofunctionappearsinthe
display.
2. Use the OCTAVE +/- buttons or
the SOUND/FAVORITE BANK
lever to select the setting.
4hr: Enabled
diS: Disabled
3. Press the SHIFT button to exit the shift function.